ZXLD1360EV7: 4 ~ 6 LEDs @ 1A, 30V in

Summary

The ZXLD1360EV7, Figure 1, is a single sided evaluation board on aluminium for the ZXLD1360 1000mA LED driver with internal switch. The evaluation board can be used to drive a 1 amp LED, or an external choice of LEDs. The number of externally connected LEDs depends on the forward voltage of the LEDs connected. The LED fitted on this evaluation board is the Ostar LEW E2A 4 led device produced by Osram.

The operating voltage is nominally 30V for the 6 led Ostar, but can be reduced for the 4 led version. The 33uH inductor used in the circuit is based on this nominal supply, which should be connected across the Vin and Gnd pins.

Note: The evaluation board does not have reverse supply protection. The nominal current for the evaluation board is set at 1000mA with a 0.1W sense resistor, R1.

Specifications

Manufacturer Diodes Incorporated
Category Lighting
Sub-Category LED Drivers - DC In
Eval Board Board not Stocked
Voltage In 30 V
Topology Step Down
Current Out 1 A
Voltage Out (Max) 24 V
Outputs and Type 1 Non-Isolated
Efficiency @ Conditions >85%, 30V in, 24V @ 1 A
Features
Switching Frequency 200 kHz
Component Count + Extras 13 + 7
Design Author Diodes/Zetex
Application / Target Market Lighting: LED Signage
Main I.C. Base Part ZXLD1360
Date Created By Author
Date Added To Library 2022-12

Support Documents & Media

ZXLD1360EV7 - Gerbers.zip ZXLD1360EV7 - User Guide ZXLD1360 - Datasheet ZXLD1350, 60, 62 - Performance Calculator

Media

ZXLD1360EV7_Schematic.JPG ZXLD1360EV7_Board.JPG